Working with SnapStone, A Floating Porcelain Tile System

Recently I had the opportunity to play with a product called SnapStone. SnapStone is a porcelain floating floor system that can be installed over most vinyl, wood and concrete sub-floors. I’ve seen this product before in my local big box store in the ‘real’ tile aisle and have always looked upon it a bit suspiciously. It couldn’t possibly rival real stone or tile, I thought. So, when the boxes of SnapStone arrived at my front door, I was excited to see how it would compare. 

First of all, SnapStone is real porcelain tile. The only difference between it and traditional tile–and it’s a big one–is it has interlocking tabs around its perimeter which allows it to float. This trick allows DIYers to put it over just about any existing structurally sound flooring. 

created at: 2010/02/15

And speaking of DIYing, let’s talk about the installation process. First, there’s no real prep work to the existing flooring itself–except that it should be clean, smooth and dry. You can start laying out tile either in the middle of the room or at a wall. Then you just line up the tabs of tile and push or tap them together using a white-headed rubber mallet. What’s great about the tabs, of course, is your grout lines are always spot on. 

You can cut SnapStone like you would traditional porcelain tile (the instructions suggested using a wet saw) but you should avoid cutting pieces that have LESS than 2 tabs left on the uncut sides. Once all the tiles are set, you’re ready to grout.

In a SnapStone installation, you MUST use SnapStone Flexible Grout. It comes in tubs which require no additives. You just have to mix it, like you would paint. I used a traditional tile float to spread the grout and then sponged off using a dry-wet sponge. 

created at: 2010/02/15

I must say, working with the flexi grout was a treat. It was much easier to spread than traditional grout as it kind of stuck together creating less grout ‘crumbs’. Sponging off was easier too. It wasn’t even what I’d consider messy, when compared to sponging off traditional grout. 

When my test floor was done, I was…well…floored! It looked great! 

created at: 2010/02/15

If after reading this post you’re all set to buy SnapStone, there’s a few things you need to know. First, after grouting, wait a good 48 to 72 hours to move furniture onto the tile. The grout does set up in about the same time as traditional grout, but it was still pliable after 24 hours. (Felt kind of like a rubber ball.) In 72, it was hard and ready for serious foot traffic. Also, setting SnapStone around the perimeter of a room isn’t quite as easy as setting regular tile. The tabs need to be finessed into place with a rubber-coated pull bar. And finally, removing a broken tile isn’t as easy as a traditional tile either, which you can just smack in the middle with a hammer and lift out. A broken SnapStone tile is removed by working your way to it from the perimeter. Again, that’s because of the interlocking tabs. That being said, a broken tile is probably a rare occurrence. 

POST UPDATE: The SnapStone folks forwarded a link to a video showing how to replace one of their tiles. 

So there you have it. SnapStone, it’s definitely a formidable contender in flooring alternatives for the DIYer. And, yes, it belongs in the tile aisle!!

For more information about the product, installation process, as well as gallery photos, follow this link to SnapStone.